Software Development Forum Index Software Development
Offshore Software Development Forum
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 



Hair Extension | Wigs | Hair Care


Engraving the metal plates for art print

 
Post new topic   Reply to topic    Software Development Forum Index -> Welcome to ForumsLand.com - Free forum hosting service
View previous topic :: View next topic  
Author Message
posterart12



Joined: 06 Jul 2013
Posts: 10
PostPosted: Sat Jul 06, 2013 10:17 am    Post subject: Engraving the metal plates for art print Reply with quote
The exposed metal lines are then etched by dipping the plate in a bath of etchant (e.g. nitric acid or ferric chloride). The etchant "bites" into the exposed metal, leaving behind lines in the plate. The remaining ground is then cleaned off the plate, and the printing process is then just the same as for engraving.
_________________
art print
Back to top
View user's profile Send private message Visit poster's website Yahoo Messenger
Free Forum
PostPosted:      Post subject: ForumsLand.com
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Software Development Forum Index -> Welcome to ForumsLand.com - Free forum hosting service All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Forum hosted by ForumsLand.com - 100% free forum. Powered by phpBB 2.


free forum make a forum for free message boards free forum hosting free phpbb forum phpbb create free forum

Report a violation